Parameter Description Navigation Values
Default
Value
Forced Stop
If programmed, the installation will stop at a
specific floor at each crossing (some hotels use
this function).
▲▼
(Increase/Decrease
◄► (Choice)
Protect floor
If a protected floor is programmed, when the
elevator car reaches the floor, the door does not
open, instead the monitor will show images
coming from the camera corresponding to that
floor. Doors can be opened only by pressing the
OPEN DOOR button; if this does not happen, the
lift moves to the previous floor and then stops the
protected floor mode (this operating mode is only
possible with DMG’s monitoring system).
▲▼
(Increase/Decrease
◄► (Choice)
Lop priority
Enabling the floor priority call function. pairing
with 16 IN card (or key inputs from BDU)
▲▼
(Increase/Decrease
◄► (Choice)
Floor
habilitation
Enabling the call enabling function (e.g. CARD
Reader). In combination with 16 IN card.
Type 1: LOP enable: to enable calls, the
corresponding input of the 16 IN card must be
closed.
Type 2: COP enabling To enable calls, the
corresponding input of the 16 IN card must be
closed
Type 3: Enable COP + LOP: to enable calls, the
corresponding input of the 16 IN card must be
closed (disabling the floor)
▲▼
(Increase/Decrease
◄► (Choice)
Shaft
Protection
Protection of compartment and doors.
For description, refer to Annex X.
▲▼
(Increase/Decrease
To Next Page
Loading...