Controller A Push-buttons Push-buttons Controller B
3
3
2
2
1
1
0
0
Controller A Controller B
Number of floors 8 6
...
Multiplex configuration
Lift number 1.0 2.1
Floors in Multiplex 8 8
OFFSET 0 0
NOTE : each button is only connected to its controller and must NOT be connected in parallel
– Example 7 –
Controller A floors Controller B floors
7 7
6 6
5 5
4 4
3 3
2 2
1 1
0 0
If this function is activated, two types of call are possible:
a) standard pressure call (the call is assigned to the nearest elevator);
b) long pressure call (more than 3 seconds of pressure); this call is assigned to the elevator with lower “Lift Number”
(MASTER); use this function if you have two elevator cars of different sizes (i.e. one for disabled passengers and one
To Next Page
Loading...