The manufacturer and technical authorised representative DMN Machinefabriek Noordwykerhout B.V.
herewith declares that the product described above is in compliance with the basic requirements of
Machine Directive 2006/42/EC with reference to the technical related documents corresponding Appendix
VII, Part B of the Directive and conforms to the following fundamental stipulations of this directive (Addendum
1): Nbr. 1.1.2; 1.1.3; 1.1.5; 1.1.6; 1.2.2; 1.2.6; 1.3.1 - 1.3.4; 1.3.6-1.3.8.2; 1.3.9; 1.4.1; 1.4.2. 1; 1.4.2.2; 1.5.1-
1.5.4; 1.5.6-1.5.9; 1.5.13; 1.6.1-1.6.5; 1.7.1; 1.7.1.1; 1.7.1.2; 1.7.2; 1.7.3; 1.7.4.1- 1.7.4.3; 2.1.1; 2.1.2.
Pressure Equipment Directive 2014/68/EU. The DMN-WESTINGHOUSE rotary valves and/or diverter
valves do not fall under the scope of this directive (see Article 1 – 2f) as they are classified no higher than
category I under article 13 of this directive.
ATEX Directive 2014/34/EU.
1. The DMN-WESTINGHOUSE Drop through valve is certified according to
Type Examination CertificateBVS03 ATEX H051 X.
D St1.
II1D (Internal)
II3D (External)
Applicable standards:
EN 1127-1:2011, EN 13463-1:2009, EN 13463-5:2011, EN 14460:2006
2. DMN Machinefabriek Noordwykerhout B.V. has a quality notification according to Annex IV
through LCIE 03 ATEX Q 8082
The notified body in charge of quality surveillance is
LCIE (0081)
33, Avenue du Général Leclerc
92260 Fontenay aux Roses
France
Check the data on the type plate and read the manual before installing the valve.
The above mentioned machine in the supplied version is designed to be incorporated into an installation or
mounted on one or more other machines. Operation is prohibited until it has been confirmed that the complete
installation or composition of machines of which the component is part of has been installed in accordance with
the Directive 2006/42/EC or any other applicable directives or national regulations. The operation and safety
instructions in the operating and maintenance manual must be complied with.
In response to a reasoned request by the national authorities relevant information on the partly completed
machinery will be submitted for inspection. Inspection of the information shall be without prejudice to the
intellectual property rights of the manufacturer of the partly completed machinery.
To Next Page
Need help?
General
