DMP CELLCOM Series - Page 4

Designed, engineered, and
manufactured in Springfield, MO
using U.S. and global components.
LT-1620 1.02 20214
CELLCOM SERIES UNIVERSAL
ALARM COMMUNICATORS
Specifications
CellCom-LTE-V
Primary Power Nominal 12VDC
Current Draw 12VDC:
Standby 75mA
Alarm 95mA (Cell Communication)
CellComF-LTE-V
Primary Power Nominal 12VDC or 24VDC
Current Draw 12VDC:
Standby 75mA
Alarm 95mA (Cell Communication)
Current Draw 24VDC:
Standby 45mA
Alarm 85mA (Cell Communication)
Certifications
Cellular
FCC Part 15: XMR201707BG96
XMR201907BG95M3
IC: 10224A-201709BG96
10224A-2019BG95M3
CellCom-LTE-V
FCC Part 15: CCKPC0207
IC: 5251A-PC0207
Underwriters Laboratory (UL) Listed
ANSI/UL 1610 Central Station Burglar (Cellular)
ANSI/UL 1023 Household Burglar
ANSI/UL 985 Household Fire Warning (CID Capture)
CellComF-LTE-V
New York City (FDNY)
Underwriters Laboratory (UL) Listed
ANSI/UL 864 Commercial Fire Protective Signaling Systems
(CID Capture)
INTRUSION • FIRE • ACCESS • NETWORKS
2500 North Partnership Boulevard
Springfield, Missouri 65803-8877
800.641.4282 | DMP.com
FCC INFORMATION
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference received, including interference that may cause undesired operation.
The antenna(s) used for this transmitter must be installed to provide a separation distance of at least 20 cm from all
persons.
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used
in accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning
the equipment o and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit dierent from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority
to operate the equipment.
If necessary, the installer should consult the dealer or an experienced radio/television technician for additional
suggestions. The installer may find the following booklet, prepared by the Federal Communications Commission, helpful:
“How to Identify and Resolve Radio‑TV Interference Problems.”
This booklet is available from the U.S. Government Printing Oce, Washington D.C. 20402
Stock No. 004‑000‑00345‑4
© 2023 Digital Monitoring Products, Inc.
Information furnished by DMP is believed to be accurate and reliable.
This information is subject to change without notice.
© 2023