Chapter 3 19
With the unit in “waiting to connect” make sure that the USB or the
RS232 cable (depending on the type of connecting cable that you are
using) is properly connected to both the unit and the PC and click on
<Connect> in DataCenter.
When a successful connection is established the files in your unit
memory will appear in DataCenter. To view their contents simply
double click on each file.
For additional information on dmq DataCenter software refer to the
manual included in the CD that you received with your QS3 or
download the manual at http://www.demeq.com/Download.html
Connection to a PC is only posible with a QS3 DL. The
QS3 B does not connect to a PC.
Touch on View Data to view the
contents stored in the memory in a grid
format.
Touch to exit the grid.
Figure 3.8: View stored data in a grid format
The QS3 stores values in groups of 100 measurements. This means that
every 100 measurements, a new lot is created (lots are indicated by
letters).
To Next Page
Loading...