To Next PageTo Next Page
Need help?Do you have a question about the DMTech FP9000L-8 and is the answer not in the manual?
Covers voltage, frequency, and maximum power consumption from the mains.
Details battery quantity, type, rated voltage, C20 rating, and charger voltage.
Describes the function of each LED indicator: POWER, FIRE, FAULT, SYS FAULT, POWER FAULT, TEST, DISABLE, OUTS, DEL OUTS, BUZZER SILENCE, SOUND SILENCE, LA, EARTH.
Flashing or constant red light for Fire condition.
Common failure indicator, flashes yellow.
Constant yellow light for system failure due to CPU stoppage.
Describes the function of the RESET, SOUND SILENCE, BUZZER SILENCE, T, and 1 buttons.
Steps for unpacking, mounting the panel, and considerations for installation location.
Details wiring fire detectors, recommended conductor types, and resistance checks.
Details current interruption, fire, direct fire currents, number of checks, and outputs.
Specifies the factory setting for current interruption detection on fire lines.
Specifies the factory setting for current detection during a fire condition.
Specifies the factory setting for direct fire detection without output delays.
Covers connection of devices to panel outputs, including controllable outputs.
Instructions for connecting executive devices to controllable outputs, including resistor/diode recommendations.
Details connections for REL Fault and REL Fire relay outputs.
Details the behavior of REL Fault and REL Fire outputs during Fault and Fire conditions.
For responsible personnel; allows operation during Security, Fire, Fault, Disabled component, and Test.
Reached by opening the front cover; allows fuse replacement, communication control, delay outputs, and module addition.
Allows replacing a burnt fuse.
Enables control of communication via the RS485 interface.
Allows configuration and control of output delays.
Allows adding the M9000R module to expand panel outputs.
For authorized personnel; allows panel repair and software modification, requiring special means.
Panel indicates Fire condition on one or several lines with specific LED and buzzer behavior.
Panel enters Fault condition due to various events like system faults, power issues, or line failures.
Panel enters Disabled component condition after manual disabling of a component or line.
Panel enters Test condition manually for setting a Fire alarm line into test.
General| Zones | 8 |
|---|---|
| Alarm Current | ≤300mA |
| Operating Temperature Range | -10°C to +50°C |
| Humidity Range | ≤95% RH (non-condensing) |
| Type | Conventional Fire Alarm Panel |
| Operating Voltage | 220V AC, 50Hz |
| Operating Current | ≤100mA |
| Certification | EN54-2, EN54-4 |
