7
The power voltage supply must conform to that specified on the rating plate of the
rapid charger.
Always inspect battery charger, cord and plug before use.
Always have damage repaired by a qualified professional.
Protect battery charger against humidity and operate only in dry areas.
The supplied charger is suitable for charging batteries only.
Charging the battery
To start the charging process plug the charger into the battery, then plug in the
battery charger to the main
The battery and charger become warm during the charging process, this is normal.
After termination of the charging process, pull charger plug out of mains socket
unplug charger from battery.
LED indicator on charger: red indicator: charging.
green indicator: charge finished.
About the charger
Disconnect the feeding before connecting or disconnecting the battery
The charger must be used only with rechargeable battery. Never use un-
rechargeable battery.
Do not expose the charger to rain or water
Insertion and Removal of Rechargeable Battery
Ensuring the correct orientation between the battery and the battery compartment,
insert the rechargeable battery into the machine. Do not apply force when inserting
the battery. Insertion can be achieved easily and without resistance. The battery must
be inserted completely until the battery retention clips on the sides of the battery
compartment automatically lock it into place. To remove the battery press the battery
retention clips and pull the battery out of its compartment.
On/Off Trigger
Use the On/Off trigger to start the machine and keep holding it for continuous
operation.
The rotation speed can be varied by depressing the On/Off trigger. The more the
trigger is pressed, the faster the rotation speed.
To switch the machine off, release the On/Off trigger
Reverse-rotation Lever
Important! The machine has to come to a complete stop before the reverse rotation
lever can be used; otherwise the machine may be damaged.
Use the reverse-rotation lever to switch between clockwise (normal) and
anticlockwise rotation or vice-versa. With the reverse-rotation lever in the central
position the trigger switch is locked and cannot be depressed. Put the reverse-
rotation lever in the central position before you put the machine down, to avoid
unintentional starting.
Always remove the battery before carrying out any work on the machine.
Care and cleaning
Keep the ventilation openings clear and clean the product regularly. Clean the
housing only with a damp cloth-do not uses any solvents! Dry thoroughly afterwards.
Caution!
If something unusual occurs during use, switch off the tool and remove the battery.
Inspect and repair the tool before using it again. Repair of the tool must only be
carried out by a qualified repair technician.
To Next Page
Loading...