User Manual C-6000i Computerized Jigging Reel
24
WAITING TIME on page 22) before it pays out the line again. When it
reaches the depth of the false bottom it will start hauling the line and
everything starts over again.
Only the values of two parameters on screen one must be changed.
HAULING POWER
The default value of this parameter is 30, which is probably too low in most
cases. It should be increased to at least 50 but the best value depends on the
number of hooks on the leader and the weight of the sinker. Common value
for 60-70 hooks is 80-90.
NOTE: The HAULING POWER should always be set high enough to
make the tear off process fluent. Use the MAXIMUM HAULING SPEED
parameter to control the speed.
RELEAX TIME
The value of this parameter must be set at zero.
MAXIMUM HAULING SPEED
The default value (25) should be suitable in most cases. If fish tends to be
thrown into the sea during the “tear-off” process decrease the value of this
parameter.
NOTE: Make sure that when the last hook on the leader has been pulled
through the stripper, the first hook has not been wound onto the drum
and that the depth counter shows zero at the place where you want the
reel to stop hauling. For detailed information about how to adjust the
zero level see the section “Set zero point (clear depth counter)” on page
15.
If a stop ring (float) is used to ensure that the leader is never wound onto
the drum, make sure that doesn’t prevent the reel from reaching zero
depth when hauling the line.
SCREEN TWO - Fishing Systems
Fishing systems hold stored values for all parameters on screen one. They
also include information on what type of jig should be used (see “SCREEN
FOUR - Jigging Types” on page 31) and they always set the number of steps
for “step-jig” to a value of five (see “STEPS” on page 30).
The fishing systems also store information about the downward jig i.e. the
factory made systems always set the parameter SPEED CONTROLLED
DOWNWARD JIG (page 31) to a value of 0 (inactive) but the “OWN
SYSTEMS” store the value of this parameter and the parameter DOWNJIG
SPEED (page 31).
To Next Page
Loading...