C-6000i Computerized Jigging Reel User Manual
25
Moving the cursor to an icon for a system and pressing the plus pad,
activates that fishing system. When a system has been activated the
corresponding icon will be displayed on screen one.
Search systems are different from the other systems since they do not hold
values for any of the parameters nor the type of jigging. If a search system is
activated the reel will use the active fishing system to search the sea for fish
i.e. it will jig a defined number of times (default: 10) at one depth, then haul
one jig length and start jigging again, then haul one jig length etc. When it
reaches the top of the search span it will check for bottom and then start all
over again. The icons show the defined search span. If the reel finds fish, it
sets a false bottom at that depth, deactivates the search system and hauls the
fish. Next time when the user makes the reel pay out it will stop at the depth
where the fish was caught and start jigging.
The user can change the search area (see SEARCH SPAN on page 30) and
the number of jigs at each depth (see SEARCH COUNT on page 30). The
section “SEARCH SYSTEMS: on page 26 explains how a search system
works.
If a search system is activated its icon will override the icon for the fishing
system as long as the search system is active. When it becomes inactive the
previous icon (the icon for the active fishing system) will be displayed again.
A search system can be deactivated by moving the cursor to one of the icons
for search systems and pressing the minus pad or by choosing one of the
other fishing systems.
DNG
This system holds the factory settings and this is the active system when the
reel is connected to a power source for the first time.
If you have trouble and have lost your way in all the parameters you can set
the basic parameters to the factory setting by activating this fishing system.
FISHING WITH BAIT
This system is used when bait is to be used on the hooks instead of rubber.
When fishing with bait the reel waits slightly at the bottom and at the top of
the jigging motion and jigs in short and slow movements. Fish sensitivity is
low.
POLLACK FISHING
Pollack fishing uses rapid jigging and high fish sensitivity. Since it is not
likely that the fish will get off the hook a powerful hauling force is used for
increased efficiency.
To Next Page
Loading...