Voltage Selection
A-2 72A-2243-01 Rev. B 9/04
September 17, 2004
6. If possible, change the nameplate with a metal stamp to indicate that the
voltage rating has been changed, or contact Doble to order a new
nameplate. Identify the unit to Doble by its serial number. Use a marker of
some type to temporarily correct the nameplate if necessary. Do not leave
the set with an incorrect voltage rating on the nameplate.
7. Change the supply cord plug to a plug recognized in your country for use
at 230 Volts, unless you are using the power supply cord supplied by
Doble to connect to the transporter system voltage plug-in supply.
To Next Page
Loading...