DOD BASSTEC User Manual

WARNING
FOR YOUR PROTECTION, PLEASE READ THE FOLLOWING:
WATER AND MOISTURE: Appliance should not be used near water (e.g. near a
bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming
pool, etc). Care should be taken so that objects do not fall and liquids are not spilled
into the enclosure through openings.
POWER SOURCES: The appliance should be connected to a power supply only of
the type described in the operating instructions or as marked on the appliance.
GROUNDING OR POLARIZATION: Precautions should be taken so that the ground-
ing or polarization means of an appliance is not defeated.
POWER CORD PROTECTION: Power supply cords should be routed so that they are
not likely to be walked on or pinched by items placed upon or against them, paying
particular attention to cords at plugs, convenience receptacles, and the point where
they exit from the appliance.
SERVICING: To reduce the risk of fire or electric shock, the user should not attempt
to service the appliance beyond that described in the operating instructions. All other
servicing should be referred to qualified service personnel.
FOR UNITS EQUIPPED WITH EXTERNALLY ACCESSIBLE FUSE RECEPTACLE:
Replace fuse with same type and rating only.
ELECTROMAGNETIC COMPATIBILITY
Operation is subject to the following conditions:
• this device may not cause harmful interference, and
• this device must accept any interference received, including interference
that may cause undesired operation.
• use only shielded interconnecting cables.
• operation of this unit within significant electromagnetic fields should be
avoided.
CAUTION
ATTENTION: RISQUE DE CHOC ELECTRIQUE - NE PAS OUVRIR
WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC
SHOCK DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE
CAUTION: TO REDUCE THE
RISK OF FIRE REPLACE ONLY
WITH SAME TYPE FUSE
ATTENTION: UTILISER
UN FUSIBLE DE RECHANGE DE
MEME TYPE
RISK OF ELECTRIC SHOCK
DO NOT OPEN
FUSES (5mm x 20mm):
100 V :T 250 mA 250 V 120 V :200 mA 250 V SLOW BLOW
220 / 240 V :T 125 mA 250 V

DOD BASSTEC Specifications

General

Brand	DOD
Model	BASSTEC
Category	Amplifier
Language	English

Summary

Safety and Precautions

General Warnings

Covers electrical shock, fire risk, rain/moisture, and fuse replacement guidelines.

Operating Environment and Power

Details precautions regarding water, power sources, grounding, and power cord protection.

Electromagnetic Compatibility

Operating the BASSTEC

Selecting Programs

Explains how to choose user and factory presets via footswitches and buttons.

Editing Programs

Details the process of changing, adding, or deleting effects and saving custom programs.

Bypassing and Tuner Activation

Covers how to bypass the unit's effects and activate the built-in tuner function.

Advanced Features

Describes Enveloped Effects and the Factory Reset procedure.

Product Accessories and Information

Accessories Overview

Lists optional accessories like the Gig Bag and VCC1 controller.

Declaration of Conformity

States compliance with safety and EMC directives for the product.

Warranty Terms

Controls and Connections

Front Panel Overview

Identifies and describes all input/output jacks, knobs, buttons, and LEDs on the unit.

Effects Reference

Factory Presets List

Lists all 93 available factory preset programs with their names.

FX List Categories

Details parameters for Master Level, Noise Gate, Modulations, Delay, Reverb, Compression, Distortion, and EQ.

Quick Start Guide

Initial Setup and Operation

Provides step-by-step instructions for connecting the guitar, amp, and powering on the unit.