To set the variance: Turn the ignition switch ON. Then,
press and hold the compass button for approximately 2
seconds. Then, press the SCROLL button until “Compass
Variance” displays in the EVIC. Both the “Compass
Variance” message and the last variance zone number
will display in the EVIC. Then, press and release the
FUNCTION SELECT button until the proper variance
zone is selected according to the map. Finally, press and
release the compass button to exit.
Telephone — If Equipped
Press and release the MENU button until “Telephone”
displays in the EVIC.
When the appropriate conditions exist the EVIC provides
the following telephone information:
•
Phone status: idle, voice mail, roaming, battery
strength and signal strength in increments of 20 per-
cent.
•
Call status: Incoming call, connecting, connected, air
time in minutes and seconds, call ended, call failed,
roaming and no phone connection.
•
UConnect Active.
UNDERSTANDING YOUR INSTRUMENT PANEL 153
4
To Next Page
Loading...
Need help?
General
