103
Controls in detail
Operating system with steering wheel buttons*
3
Press the æ or ç to select the
Lighting
submenu.
Press the j or k button repeat-
edly until you see the
Hdlmp. mode
mes-
sage in the display.
The current setting is highlighted.
Press the æ or ç button to se-
lect whether you wish to operate the
lighting manually or whether you wish
to set constant headlamp mode.
Switching the locator lighting on or off*
If you switch the locator lighting to
On
, the
following lamps light up in the dark after
you have unlocked the vehicle using the
key:
The parking lamps
The tail lamps
The license plate lamp
The front foglamps
The locator lighting automatically switches
off after 40 seconds or when you:
open the driver’s door
insert the key into the ignition lock
lock the vehicle with the key
Press the æ or ç to select the
Lighting
submenu.
Press the j or k button repeat-
edly until you see the
Loc. lighting
message in the display.
The current setting is highlighted.
Press the æ or ç button to
switch the locator lighting
On
or
Off
.
i
For safety reasons, it is not possible to
reset the
Hdlmp. mode
function to the
factory setting while the vehicle is in
motion. You will see the following mes-
sage in the display:
Setting only pos-
sible at standstill
N54.32-2268-31
USA only:
If you turn the light switch to C
or B, the corresponding light
switches on. Constant headlamp mode
remains activated if the light switch is
turned to U.
Canada only:
If you turn the light switch to B, the
low-beam headlamps are switched on.
Constant headlamp mode remains acti-
vated if the light switch is turned
to C or U.
N54.32-2269-31
To Next Page
Loading...
