108
Controls in detail
Operating system with steering wheel buttons*
3
Switch on the cell phone and audio sys-
tem or COMAND APS*.
See the separate operating instruc-
tions.
Press the è or ÿ button repeat-
edly until you see the
TEL
menu in the
display.
You will see different messages in the
display, depending on the status of
your cell phone:
If the cell phone is switched off, you
will see the
TEL off
message
(Sound 20) or
Tel Turn on
message
(COMAND APS*) in the display.
If you have not yet entered a PIN,
you will see the
TEL PIN
message
(Sound 20) or
Enter PIN
message
(COMAND APS*).
Enter the PIN code using the cell
phone, audio system or
COMAND APS*.
The cell phone searches for a network. The
display remains blank during this time.
As soon as the cell phone has found a net-
work, you will see the
Ready
message in
the display.
Once it has shown its operational readi-
ness, you can operate the cell phone using
the operating system.
Rejecting a call
If you do not wish to speak to the person
who is calling, you can reject the call.
Press the t button.
The caller then hears the busy signal.
Accepting a call
You can accept a call at any time, provided
the cell phone is ready to receive calls.
Press the s button.
The call duration is shown in the dis-
play.
Ending a call
Press the t button.
The display now shows the operational
readiness symbol again.
Dialing a number from the phone book
You may select and dial a number from the
phone book at any time, provided the cell
phone is ready to receive calls.
Press the è or ÿ button repeat-
edly until you see the
TEL
menu with
the operational readiness symbol in the
display.
N54.32-2276-31
i
It is only possible to create new phone
number entries in the phone book us-
ing the cell phone itself. See the sepa-
rate operating instructions.
To Next Page
Loading...
