28
Safety
Occupant safety
2
Adjust the belt height in such a way that
the shoulder belt is routed over the middle
of the shoulder.
Belt sash guide with height adjustment
5 Release button
To raise the belt height: slide belt
sash guide 1 upward.
Belt sash guide 1 engages in various
positions.
To lower the belt height: press and
hold release button 5.
Slide belt sash guide 1 to the desired
height.
Let go of release button 5 and make
sure that belt sash guide 1 engages.
The SRS (S
upplemental Restraint System)
may consist of the following components,
depending on the equipment level:
1 warning lamp
Emergency tensioning retractors
Belt force limiters
Airbag system with:
Airbag control unit
Airbags
1 warning lamp
The SRS performs a self-test at regular in-
tervals when the ignition is switched on
and while the engine is running. Malfunc-
tions can therefore be detected in good
time.
The 1 warning lamp in the instrument
cluster ( page 14) comes on for approxi-
mately 4 seconds when you switch on the
ignition.
SRS (Supplemental Restraint
System)
Warning G
A malfunction has occurred if the 1
warning lamp:
does not come on when you switch on
the ignition
does not go out after approximately 4
seconds
lights up again
Individual systems may be activated unin-
tentionally or may not be triggered in the
event of an accident with a high rate of vehi-
cle deceleration.
To Next Page
Loading...
