73
Controls in detail
Seats
3
Removing the head restraints
Pull the head restraint up as far as it
will go.
Press release button 1 and pull the
head restraint out.
Installing the head restraints
Insert the head restraint so that the rod
with the notches is in the direction of
travel on the left.
Push the head restraint down until it
engages.
The switches for the driver’s and co-
driver’s seat are on the center console.
1 Normal heating
2 Rapid heating
Switch on the ignition ( page 67).
Normal heating
To switch on: press upper part of the &
switch.
An indicator lamp in the switch comes
on.
To switch off: press upper part of the &
switch again.
The indicator lamp in the switch goes
out.
Rapid heating
To switch on: press lower part of the
switch.
Both indicator lamps in the switch
come on.
To switch off: press lower part of the
switch again.
The indicator lamps in the switch go
out.
To switch down to normal heating:
press upper part of the & switch.
!CAUTION
Make sure that the head restraint is re-
installed in such a way that its front fac-
es in the direction of travel (comfort
head restraint).
Seat heating*
N54.25-2918-31
i
The seat heating switches automatical-
ly to normal heating mode after approx-
imately 5 minutes.
Only one indicator lamp in the switch
remains lit.
To Next Page
Loading...
