Rear Tail, Stop, Turn Signal, Side Marker and
Backup Lights
1. Raise the liftgate.
2. Remove the tail light assembly by removing the two
screws from the inboard side. Use a fiber stick or similar
tool to gently pry the light on the outboard side to
disengage the two ball studs.
NOTE:
•
If a screwdriver is used, make sure a soft material is
placed between the vehicle body and tool so not to
scratch the paint.
•
The PRY location is best closest to the studs while
dislodging them separately.
Removing Tail Light Assembly
484 MAINTAINING YOUR VEHICLE
To Next Page
Loading...
