Phone Button
The rearview mirror contains the microphone
for the system (depending on the type of
mirror and radio equipped), and either the
radio or the mirror has the two control buttons
(PHONE Button and VOICE RECOGNITION button)
that will enable you to access the system.
Voice Recognition Button
Actual button location may vary with the ra-
dio. The individual buttons are described in the
“Operation” section.
The uconnect威 phone can be used with any Hands-Free
Profile certified Bluetooth威 cellular phone. See the
uconnect威 website for supported phones. If your cellular
phone supports a different profile (e.g., Headset Profile)
you may not be able to use any uconnect威 phone
features. Refer to your cellular service provider or the
phone manufacturer for details.
The uconnect威 phone is fully integrated with the vehi-
cle’s audio system. The volume of the uconnect威 phone
can be adjusted either from the radio volume control
knob or from the steering wheel radio control (right
switch), if so equipped.
The radio display will be used for visual prompts from
the uconnect威 phone such as ⬙CELL⬙ or caller ID on
certain radios.
Operation
Voice commands can be used to operate the uconnect威
phone and to navigate through the uconnect威 phone
menu structure. Voice commands are required after most
uconnect威 phone prompts. You will be prompted for a
specific command and then guided through the available
options.
•
Prior to giving a voice command, one must wait for
the beep, which follows the ⬙Ready⬙ prompt or another
prompt.
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 85
3
To Next Page
Loading...
