Dodge 2012 Caliber - Before You Begin Programming Homelink

NOTE: HomeLink威 is disabled when the Vehicle Secu-
rity Alarm is active.
Before You Begin Programming HomeLink姞
Be sure that your vehicle is parked outside of the garage
before you begin programming.
For more efficient programming and accurate transmis-
sion of the radio-frequency signal it is recommended that
a new battery be placed in the hand-held transmitter of
the device that is being programmed to the HomeLink威
system.
Erase all channels before you begin programming. To
erase the channels place the ignition in the ON/RUN
position and press and hold the two outside HomeLink威
buttons (I and III) for up 20 seconds or until the red
indicator flashes.
NOTE:
• Erasing all channels should only be performed when
programming HomeLink威 for the first time. Do not
erase channels when programming additional buttons.
HomeLink威 Buttons/Sunvisor/Headliner
3
UNDERSTANDING THE FEATURES OF YOUR VEHICLE 165