Programming A Rolling Code
For programming garage door openers that were manu-
factured after 1995. These garage door openers can be
identified by the “LEARN” or “TRAIN” button located
where the hanging antenna is attached to the garage door
opener. It is NOT the button that is normally used to
open and close the door. The name and color of the
button may vary by manufacturer.
1. Turn the ignition switch to the ON/RUN position.
2. Place the hand-held transmitter 1 to 3 inches (3 to
8 cm) away from the HomeLink威 button you wish to
program.
Training The Garage Door Opener
1 — Door Opener
2 — Training Button
154 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
To Next Page
Loading...
