EasyManua.ls Logo

Dodge 2015 DURANGO - Page 164

Dodge 2015 DURANGO
236 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
CAUTION!
DO NOT dolly tow any A WD vehicle. Towing with only one set of wheels on the
ground (front or rear) will cause severe transmission and/or transfer case damage.
Tow with all four wheels either ON the ground, or OFF the ground (using a vehicle
trailer).
Tow only in the forward direction. Towing this vehicle backwards can cause severe
damage to the transfer case.
The transmission must be in P ARK for recreational towing.
Before recreational towing, perform the procedure outlined under “Shifting Into
NEUTRAL(N)” to be certain that the transfer case is fully in NEUTRAL (N).
Otherwise, internal damage will result.
Towing this vehicle in violation of the above requirements can cause severe
transmission and/or transfer case damage. Damage from improper towing is not
covered under the New V ehicle Limited W arranty.
Do not use a bumper-mounted clamp-on tow bar on your vehicle. The bumper face
bar will be damaged.
Shifting Into NEUTRAL (N)
WARNING!
You or others could be injured or killed if you leave the vehicle unattended with the
transfer case in the NEUTRAL (N) position without first fully engaging the parking
brake. The transfer case NEUTRAL (N) position disengages both the front and rear
driveshafts from the powertrain and will allow the vehicle to roll, even if the transmis-
sion is in P ARK. The parking brake should always be applied when the driver is not in
the vehicle.
Use the following procedure to prepare your vehicle for recreational towing.
CAUTION!
It is necessary to follow these steps to be certain that the transfer case is fully in
NEUTRAL (N) before recreational towing to prevent damage to internal parts.
1. Bring the vehicle to a complete stop, with the engine running.
2. Press and hold the brake pedal.
3. Shift the transmission into NEUTRAL.
4. Using a ballpoint pen or similar object, press and hold the recessed transfer case
NEUTRAL (N) button (located by the selector switch) for four seconds. The light
behind the N symbol will blink, indicating shift in progress. The light will stop blinking
UTILITY
162

Table of Contents

Related product manuals