Dodge challenger 2017 - Automatic High Beam - if Equipped

Complete The Android Pairing Procedure: 1. Confirm the passkey shown on the mobile
phone matches the passkey shown on the
Uconnect system then accept the Bluetooth
pairing request.
NOTE:
Some mobile phones require the PIN to be en-
tered manually, enter the PIN number shown on
the Uconnect screen.
For further information on Uconnect Phone,
please refer to “Uconnect Phone” in the vehicle’s
User Guide.
Automatic High Beam — If
Equipped
This system automatically controls the operation
of the headlamp high beams as oncoming vehicles
approach.
•
The Automatic High Beam Headlamp Control can
be turned on or off using the Uconnect System.
• Push the turn signal lever away from you.
•
With the headlight switch in the “AUTO” posi-
tion, the high beams are controlled automatically
• Pull the turn signal lever toward you to manu-
ally deactivate the system.
• To improve system recognition of crossing traf-
fic and to limit use in a residential area, the
vehicle must be moving at a speed greater than
20 mph (32 km/h) before the Automatic High
Beam Module (AHBM) begins requesting high
beam activation.
NOTE:
If the windshield or Automatic High Beam Head-
lamp Control mirror is replaced, the mirror must
be re-aimed to ensure proper performance. See
your local authorized dealer.
Pairing Request
LIGHTS