NOTE: To avoid unintentional shut downs, the system
will disable the one time push of the REMOTE START
button for two seconds after receiving a valid
Remote Start request.
To Exit Remote Start Mode And Drive The Vehicle
Before the end of 15-minute cycle, push and release the
UNLOCK button on the key fob to unlock the doors, or
unlock the vehicle using Passive Entry via the door
handles, and disarm the Vehicle Security Alarm (if
equipped). Then, prior to the end of the 15-minute cycle,
push and release the keyless ignition button.
NOTE: For vehicles equipped with the Keyless Enter-
N-Go — Ignition feature, the message “Remote start
active - Push start button” will display in the Driver
Information Display (DID) until you push the START
button.
Cancel Remote Start
Remote Starting will also cancel if any of the following
occur:
• The engine stalls or engine speed exceeds 2500 rpm.
• Any engine warning lights come on.
• Low Fuel Light turns on.
• The hood is opened.
• The hazard switch is pushed.
• The gear selector is moved out of PARK.
• The brake pedal is pushed.
General Information
The following regulatory statement applies to all Radio
Frequency (RF) devices equipped in this vehicle:
30 THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
To Next Page
Loading...
