10. Push out the small center cap using the jack tool from
inside the aluminum road wheel and position the
wheel behind the rear bumper with the “beauty side”
facing rearward.
NOTE: The plastic plate will prevent the road wheel
from being scratched when sliding it under the vehicle.
11. Insert the two long tubes on the plastic protective
plate in the lug holes of the road wheel. Push the end
of the winch’s cable, spring, steel sleeve and stamped
cone shape wheel plate though the road wheel and
protective plate.
“Beauty Side”
Installing Winch
6
WHAT TO DO IN EMERGENCIES 589
To Next Page
Loading...
