1. Jamming due to electronic devices or driving next to
facilities emitting the same Radio Frequencies as the
TPM sensors.
2. Installing some form of aftermarket window tinting
that affects radio wave signals.
3. Lots of snow or ice around the wheels or wheel
housings.
4. Using tire chains on the vehicle.
5. Using wheels/tires not equipped with TPM sensors.
The DID will also display a ⬙SERVICE TPM SYSTEM⬙
message for a minimum of five seconds when a system
fault is detected possibly related to an incorrect sensor
location fault. In this case, the ⬙SERVICE TPM SYSTEM⬙
message is then followed by a graphic display, with
pressure values still shown. This indicates the pressure
values are still being received from the TPM Sensors but
they may not be located in the correct vehicle position.
However, the system still needs to be serviced as long as
the ⬙SERVICE TPM SYSTEM⬙ message exists.
5
STARTING AND OPERATING 499
To Next Page
Loading...
