To Set A Memory Position:
1. Cycle the vehicle’s ignition to the ON/RUN
position (Do not start the engine).
2. Adjust all memory profile settings.
3. Push and release the S (set) button.
4. Push and release the 1 or 2 button within five
seconds.
To Program A Key Fob To The Memory Position:
1. Cycle the vehicle’s ignition to the OFF position.
2. Select the desired memory profile, 1 or 2.
3. Push and release the S (set) button on the
memory switch, then within five seconds,
press and release the 1 or 2 button accord-
ingly.
4. Push and release the lock button on the key fob
within 10 seconds.
NOTE:
Memory seats can be programmed/stored while
the engine is running.
For further information, and applicable warnings
and cautions, please refer to the Owner’s Manual
at
www.mopar.com/en-us/care/owners-manual.html
(U.S. Residents) or www.owners.mopar.ca (Cana-
dian Residents).
Wiper/Washer Controls
The multifunction lever is located on the left side
of the steering column.
Front Wiper Operation
The front wipers are operated by rotating a switch,
located on the end of the lever.
Multifunction Lever
WINDSHIELD
WIPER/WA SHER FEA TURES
To Next Page
Loading...
