Push and hold the two outside HomeLink
®
buttons for 20 seconds until the
orange indicator ashes. An individual channel cannot be erased.
TO ERASE ALL SET CHANNELS:
Garage Door Opener
11
While the car is ON, hold the handheld garage door transmitter 1-3 inches
from the HomeLink
®
button you want to program in the vehicle.
22
Push and hold both the HomeLink
®
button being programmed and the
button on the garage door transmitter.
NEED ASSISTANCE?
1-800-355-3515
55
If the programming was successful, your garage door should
open and close with your chosen HomeLink
®
button.
4 4
For Rolling Code
garage door openers only, rmly push and release
the “LEARN” or “TRAIN” button on your garage door opener
motor in your garage, then push the HomeLink
®
button in
your vehicle for two long presses.
33
For Non-Rolling Code garage door openers, watch for the indicator
light to go constant.
For Rolling Code garage door openers, watch for the indicator light
to go from a slow blink to blinking rapidly.
Scan For
HomeLink
®
Video
LINK YOUR GARAGE DOOR
ROLLING OR NON-ROLLING?
Check your garage door opener motor in your garage for a
“LEARN” or “TRAIN” button by the hanging antenna. If you
have one of these, you have a Rolling Code garage door opener.
??
To Next Page
Loading...
