Refrigerant Recovery And Recycling R-134a
— If Equipped
R-134a Air Conditioning Refrigerant is a hydro-
fluorocarbon (HFC) that is an ozone-friendly
substance. The manufacturer recommends that
air conditioning service be performed by an
authorized dealer or other service facilities using
recovery and recycling equipment.
NOTE:
Use only manufacturer approved A/C system
PAG compressor oil and refrigerants.
Refrigerant Recovery And Recycling —
R–1234yf
R–1234yf Air Conditioning Refrigerant is a hy-
drofluoroolefin (HFO) that is endorsed by the
Environmental Protection Agency and is an
ozone-friendly substance with a low global-
warming potential. The manufacturer recom-
mends that air conditioning service be per-
formed by an authorized dealer using recovery
and recycling equipment.
NOTE:
Use only manufacturer approved A/C system
PAG compressor oil, and refrigerants.
Air Conditioning Filter Replacement (A/C
Air Filter)
Refer to the “Service and Warranty Handbook”
for the proper maintenance intervals.
WARNING!
Do not remove the cabin air filter while the
vehicle is running, or while the ignition is in
the ACC or ON/RUN mode. With the cabin air
filter removed and the blower operating, the
blower can contact hands and may propel dirt
and debris into your eyes, resulting in per-
sonal injury.
The A/C air filter is located in the fresh air inlet
behind the glove compartment. Perform the
following procedure to replace the filter:
1. Open the glove compartment and remove all
contents.
2. There are glove compartment travel stops on
both sides of the glove compartment door,
partially close the glove compartment door
and push inward to release the glove com-
partment travel stop on one side and repeat
this procedure for the opposite side.
3. Pull the right hand side of the glove compart-
ment door toward the rear of the vehicle to
disengage the glove compartment door from
its hinges.
NOTE:
When disengaging the glove compartment door
from its hinges, there will be some resistance.
4. With the glove compartment door loose, re-
move the glove compartment tension tether
and tether clip by sliding the clip toward the
face of the glove compartment door and
lifting the clip out of glove compartment door.
Glove Compartment
1 — Glove Compartment Travel Stops
2 — Glove Compartment Tension Tether
3 — Glove Compartment Door
231
To Next Page
Loading...
