EasyManua.ls Logo

Dodge journey 2013 - GETTING STARTED; KEY FOB

Dodge journey 2013
108 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
KEY FOB
Locking And Unlocking The
Doors/Liftgate
Press the LOCK button once to lock all the
doors and the liftgate. Press the UNLOCK
button once to unlock the drivers door
only and twice within five seconds to
unlock all the doors and liftgate.
All doors can be programmed to unlock
on the first press of the UNLOCK button.
Refer to Programmable Features in the
Electronics section of this guide.
Panic Alarm
Press the PANIC button once to turn the panic alarm on.
Wait approximately three seconds and press the button a second time to turn the panic
alarm off.
Emergency Key
Should the battery in the vehicle or the Key Fob transmitter go dead, there is an emergency
key located in the Key Fob. To remove the emergency key, slide the button at the back of the
Key Fob sideways with your thumb and then pull the key out with your other hand.
WARNING!
When leaving the vehicle, always remove the key fob from the ignition and lock your
vehicle.
Never leave children alone in a vehicle, or with access to an unlocked vehicle.
Allowing children to be in a vehicle unattended is dangerous for a number of reasons.
A child or others could be seriously or fatally injured. Children should be warned not
to touch the parking brake, brake pedal or the shift lever.
Do not leave the key fob in or near the vehicle (or in a location accessible to children),
and do not leave a vehicle equipped with Keyless Enter-N-Go™ in the ACC or ON/RUN
mode. A child could operate power windows, other controls, or move the vehicle.
REMOTE START
Press the REMOTE START button on the Key Fob twice within five seconds. Pressing
the REMOTE START button a third time shuts the engine off.
To drive the vehicle, press the UNLOCK button and cycle the ignition to the ON/RUN
position.
With remote start, the engine will only run for 15 minutes (timeout) unless the ignition is
cycled to the ON/RUN position.
The vehicle must be cycled to the ON/RUN position after two consecutive timeouts.
x
2
GETTING STARTED
8

Table of Contents

Related product manuals