Dodge journey 2017 - Keyless Enter-N-Go - Ignition

KEYLESS ENTER-N-GO — IGNITION
Engine Starting/Stopping
Starting
Normal starting of the vehicle can only
happen with a valid Keyless Enter-N-Go key
fob inside the vehicle.
1. Place the gear selector in P ARK or NEU-
TRAL.
2. While pressing the brake pedal, push
the ENGINE ST AR T/STOP button once.
If the engine fails to start, the starter will
disengage automatically after 10 sec-
onds.
3. To stop the cranking of the engine prior
to the engine starting, push the button
again.
NOTE:
In case the ignition switch does not change with the push of a button, the key fob may
have a low or dead battery. In this situation, a back up method can be used to operate the
ignition switch. Put the nose side of the key fob against the ENGINE ST AR T/STOP button
and push to operate the ignition switch.
Stopping
1. Bring the vehicle to a complete stop.
2. Place the gear selector in PARK.
3. Push the ENGINE START/STOP button once. The ignition switch will return to the OFF
position.
If the gear selector is not in PARK, the ENGINE START/STOP button must be held for two
seconds and vehicle speed must be above 5 MPH (8 km/h) before the engine will shut off.
Accessory Positions With Engine Off
NOTE:
The following functions are with the driver’s foot OFF the Brake Pedal (Transmission in
PARK or NEUTRAL Position).
Starting With The Ignition Switch In The OFF Position:
1. Push the ENGINE START/STOP button once to change the ignition switch to the ACC
position.
Engine Start/Stop Button
GETTING STARTED
12