Three-Way Calling
To initiate three-way calling, press the “Voice Recogni-
tion” button while a call is in progress and make a second
phone call as described under 9Making a Second Call
while Current Call in Progress.9 After the second call has
established, press and hold the “Phone” button until you
hear a double beep indicating that the two calls have
been joined into one conference call.
Call Termination
To end a call in progress, momentarily press the “Phone”
button. Only the active call(s) will be terminated and if
there is a call on hold, it will become the new active call.
If the active call is terminated by the far end, a call on
hold may not become active automatically. This is cell
phone dependent. To bring the call back from hold, press
and hold the “Phone” button until you hear a single
beep.
Redial
•
Press the “Phone” button to begin.
•
After the 9Ready9 prompt and the following beep, say
9Redial.9
•
The UConnect™ system will call the last number that
was dialed on your cellular phone.
NOTE: This may not be the last number dialed from the
UConnect™ system.
Call Continuation
Call continuation is progression of a phone call on
UConnect™ system after the vehicle ignition key has
been switched to off. Call continuation functionality
available on the vehicle can be any one of three types:
•
After ignition key is switched off, a call can continue
on the UConnect™ system either until the call ends or
100 UNDERSTANDING THE FEATURES OF YOUR VEHICLE
To Next Page
Loading...
