Dodge Viper - Lap;Shoulder Belt Untwisting Procedure

To Deactivate
A soft tap on the brake pedal, pushing the CANCEL button, manually accelerating 10 mph
(16 km/h) above the set speed or normal brake pressure while slowing the vehicle will
deactivate the Electronic Speed Control without erasing the set speed memory.
Pushing the ON/OFF button or turning the ignition switch OFF erases the set speed
memory.
To Resume Speed
To resume a previously set speed, push the RES (+) button and release. Resume can be
used at any speed above 20 mph (32 km/h).
To Vary The Speed Setting
To Increase Speed
When the Electronic Speed Control is set, you can increase speed by pushing the RES (+)
button.
The drivers preferred units can be selected through the instrument panel settings if
equipped. Refer to “Understanding Y our Instrument Panel” in the Owner’s Manual on the
DVD for more information. The speed increment shown is dependent on the selected
speed unit of U.S. (mph) or Metric (km/h):
U.S. Speed (mph)
• Pushing the RES (+) button once will result in a 1 mph increase in set speed. Each
subsequent tap of the button results in an increase of 1 mph.
• If the button is continually pushed, the set speed will continue to increase until the
button is released, then the new set speed will be established.
Metric Speed (km/h)
• Pushing the RES (+) button once will result in a 1 km/h increase in set speed. Each
subsequent tap of the button results in an increase of 1 km/h.
• If the button is continually pushed, the set speed will continue to increase until the
button is released, then the new set speed will be established.
To Decrease Speed
When the Electronic Speed Control is set, you can decrease speed by pushing the SET (-)
button.
The drivers preferred units can be selected through the instrument panel settings if
equipped. Refer to “Understanding Y our Instrument Panel” in the Owner’s Manual on the
DVD for more information. The speed decrement shown is dependant on the selected
speed unit of U.S. (mph) or Metric (km/h):
U.S. Speed (mph)
• Pushing the SET (-) button once will result in a 1 mph decrease in set speed. Each
subsequent tap of the button results in a decrease of 1 mph.
OPERATING YOUR VEHICLE
33