ELECTRONIC SPEED CONTROL
When engaged, the Electronic Speed Control takes over accelerator operations at speeds
greater than 25 mph (40 km/h).
The Electronic Speed Control buttons are located on the right side of the steering wheel.
NOTE:
In order to ensure proper operation, the
Electronic Speed Control System has been
designed to shut down if multiple speed
control buttons are pushed at the same
time. If this occurs, the Electronic Speed
Control System can be reactivated by
pushing the Electronic Speed Control ON/
OFF button and resetting the desired ve-
hicle set speed.
To Activate
Push the ON/OFF button to activate the
Electronic Speed Control. The Cruise Indi-
cator Light in the Driver Information Display
(DID) will illuminate. To turn the system off,
push the ON/OFF button a second time.
The Cruise Indicator Light will turn off. The
system should be turned off when not in
use.
WARNING!
Leaving the Electronic Speed Control system on when not in use is dangerous. You
could accidentally set the system or cause it to go faster than you want. You could lose
control and have an accident. Always leave the system OFF when you are not using it.
To Set A Desired Speed
Turn the Electronic Speed Control ON. When the vehicle has reached the desired speed,
push the SET (-) button and release. Release the accelerator and the vehicle will operate
at the selected speed.
NOTE:
The vehicle should be traveling at a steady speed and on level ground before pushing
the SET (-) button.
Electronic Speed Control Switches
1 — Push Cancel
2 — Push On/Off
3 — Push Resume/Accel
4 — Push Set/Decel
OPERATING YOUR VEHICLE
32
To Next Page
Loading...
