EasyManuals Logo

DOEPFER A-100 Series User Guide

DOEPFER A-100 Series
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #11 background imageLoading...
Page #11 background image
Check very carefully that it is connected so that the coloured marking on the
ribbon cable is at the bottom of the bus connector. The coloured marking
has to align with the "-12V" printing on the bus board next to the pin header. In
addition there is a line marked "RED WIRE" on the A-100SSB pc board.
Check also very carefully that it is pushed fully home, not at a slight angle
and not vertically or horizontally displaced .
Failure to check this may result in the module’s and/or supply's instant
destruction as soon as the power is turned back on!
When you’re installing extra modules, it may be necessary to take another
module or two out, to allow you easier access to the bus board.
Remove or install modules only during POWER OFF !
Additional information about the modular system A-100 is available on our website
www.doepfer.com. Important links are e.g.
www.doepfer.com Æ Products Æ A-100 Æ Technical details
www.doepfer.com Æ Products Æ A-100 Æ Mechanical details
www.doepfer.com Æ FAQ Æ A-100 Æ ....

Other manuals for DOEPFER A-100 Series

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the DOEPFER A-100 Series and is the answer not in the manual?

DOEPFER A-100 Series Specifications

General IconGeneral
TypeModular Synthesizer System
ManufacturerDoepfer Musikelektronik GmbH
Power SupplyExternal Power Supply
Current ConsumptionDepends on modules installed
DimensionsVaries by case size
Number of SlotsVaries by case size
WidthVaries by case size

Related product manuals