11
CLEANING
Rinse drip tray with water and clean it with a
little washing-up liquid and brush.
Rinse both side of the capsule holder with
water and then dry. You can also put it in a
dishwasher.
Rinse and clean water tank. Afterwards rell
with fresh, drinking water and insert it into ma-
chine. The water tank is not dishwasher proof!
Switch machine on. Power button starts blink-
ing red while machine is heating up. This takes
approx. 30 seconds. When the power button
light is steady green, the machine is ready.
30 sec
Place drip grid on drip tray. Then insert drip
tray at desired position on machine. Clean
machine with a soft damp cloth. Dry it after-
wards with a soft dry cloth.
Open locking handle and insert empty capsule
holder. Close locking handle and place an
empty container underneath the coee outlet.
Wait until the lever comes back to the middle
and rinsing stops. Empty and clean the jug.
Set the bar display to the maximum level using
the volume selector. Move lever to the right to
start rinsing.
1
4
7
2
5
8
3
6
To Next Page
