English
Operation
- 13 -
Keypad Program Tone Setting
When a key is pressed, a beep tone is heard to confirm your command. The user may enable or
disable this keypad program tone.
1. Press the MENU (8) key several times, until the Bp (P) indication appears and the keypad
tone icon (A) will blink on the LCD display.
2. Press the UP (5) or DOWN (7) keys to set the desired selection on (keypad tone enabled)
or oF (keypad tone disabled).
3. To confirm the selection and exit the Menu Mode, press the PTT key (15) or press the
MENU (8) key to move to the next function.
4. When the Keypad tone is enabled, the tone icon (A) appears on the LCD display.
Roger Beep Tone Setting
The radio is equipped with a user selectable Roger Beep Tone feature, which enables you to
send a Beep Tone at the end of each transmission after every release of the PTT (15) key. This
will prompt any receiving unit that your transmission has ended. To enable or disable this
function, please proceed as follows :
1. Press the MENU (8) key several times, until the rb (P) indication appears and the tone
icon (B) will blink on the LCD display.
2. Press the UP (5) or DOWN (7) keys to set the desired selection on (Roger Beep tone
enabled) or oF (Roger Beep tone disabled).
3. To confirm the selection and exit the Menu Mode, press the PTT key (15) or press the
MENU (8) key to move to the next function.
4. When the Roger Beep tone is enabled, the tone icon (B) appears on the LCD display.
Call Tone Setting
The radio is equipped with 3 user selectable Call tone melodies. To set the desired Call tone
melody, please proceed as follows :
1. Press the MENU (8) key several times, until the CA (P) indication and melody number (N)
will blink on the LCD display.
2. Press the UP (5) or DOWN (7) keys to set the desired melody (01-02-03).
3. To confirm the selection and exit the Menu Mode, press the PTT key (15) or press the
MENU (8) key to move to the next function.
4. To transmit the CALL tone, quickly press the PTT key (15) twice.
To Next Page
Loading...