STEP 3: Assemble the side support frame
Attach the lower half and upper half of the side frames using the bolts and split washers. Note the Dolphin logo
faces outwards from the boat Note the bolt heads will be consealed in the counter sunk area and face inwards
towards the console. Note you have a Port and Starboard Side Frame as described above logos facing
outwards
STEP 4: Attach the ball clamps to top of Side Frames
The top of the side frame has a counter sunk circle with a threaded hole, the ball clamps have a raised circle
area. Insert the raised circle area into the counter sunk hole of the side frame insert bolt from inside the ball
clamp into the side frame end and tighten. NOTE Allow the ball clamp to rotate very slightly for adjustment.
To Next Page
Loading...