To Next PageTo Next Page
Need help?Do you have a question about the Dometic GROUP SeaLand VacuFlush HTS-VG and is the answer not in the manual?
General| Flush Technology | VacuFlush |
|---|---|
| Bowl Material | Vitreous china |
| Brand | Dometic |
| Model | VacuFlush HTS-VG |
| Flush System | Vacuum |
| Voltage | 12V DC |
Manual must be read and understood before installation, adjustment, service, or maintenance.
Systems molded from linear low density polyethylene (LLDP) resin for corrosion resistance.
Hose connections on top of tank and unique diptube design minimize residual contents.
Models comply with ISO 8099:2000(E) standard and US Coast Guard requirements.
Extra-heavy wall thickness and TankSaver™ valve prevent odor permeation and tank damage.
Most models have two discharge outlets for deck or pump connection.
Position low in hull, avoid heat sources, consider filled weight and trim.
Ensure surface supports entire tank area, avoid puncturing, do not block bilge.
Eliminate unnecessary runs, use rigid pipe where possible, simplify hose layout.
Diagram showing connections for VacuFlush models.
Diagram showing connections for basic HTS models.
Use liquid dish soap, avoid lubricants, do not restrict pull, support hose properly.
Avoid sharp bends, use trough support, support hose every 12 inches.
Secure each hose connection with two hose clamps, position screws 180° apart.
Use PVC cleaner and cement, twist and hold, allow adequate cure time.
Ensure free flow, use non-reinforced hose, avoid heat, do not install below tank top.
Install for easy access to inspection port, pump, and filter; use maintenance valve.
Rinse tank after discharge, use specified cleaner, avoid harsh chemicals.
Pump out, flush, use only propylene glycol antifreeze without alcohol.
Monitors tank levels (Empty, Low, Mid, Full) with micro-float switches.
Combines vacuum tank and pump for efficient flushing in HTS-VG models.
Prevents tank implosion from high dockside vacuum by opening automatically.
Filters odors from tank vent, keeping air clean and pleasant.
Dry-run capable pump for overboard discharge, check regulations.
Provides superior odor barrier resistance for all 1 1/2-inch connections.
Removes waste from top of tank, reducing stagnant sewage and odor.
Non-corrosive PVC ball valve with Teflon seals.
Various fittings like menders, bends, adapters, tees, and wyes for 1 1/2" hose.
Fittings for 1 1/2" PVC pipe, including couplings, elbows, and adapters.
Includes rigid PVC pipe and OdorSafe Plus sanitation hose, vent hose.
Provide HTS Model Number, Serial Number, and Part Number for assistance.
Contact for service, maintenance, and authorized service centers.
Details warranty coverage, exclusions, and implied warranties for the product.
