RMLT9xxx Installing the refrigerator-oven combination
13
• Too large a gap between the refrigerator-oven combination and rear wall leads
to poor performance and increases the power consumption of the refrigerator.
Reduce the space behind the refrigerator-oven combination to create adequate
air inlet and outlet ventilation (fig. 6).
• The refrigerator-oven combination must not be installed at the side of the air inlet
and outlet vents as this leads to poor performance and increases the power
consumption of the refrigerator.
• The air inlet and outlet vents must not be covered by vehicle parts (such as an
open door or by installing accessories such as bicycle racks) while operating.
• Install the refrigerator-oven combination so that it is protected from excessive
heat, as this leads to poor performance and increases the power consumption of
the refrigerator.
• The electrical installation must comply with national and local regulations.
European standards: EN 60335-1, EN 60335-2-24, EN 1648-1 and EN 1648-2.
• The gas installation must comply with national and local regulations.
European standard: EN 1949.
• The refrigerator-oven combination must be installed in a draught-proof location
in accordance with EN 1949, see chapter “Installing the refrigerator-oven combi-
nation in a draught-free location” on page 14.
RMLT9xxx-I-AUS.book Seite 13 Donnerstag, 7. Dezember 2017 12:53 12
To Next Page
Loading...
Need help?
General
