RMLT9xxx Safety instructions
5
2.1 General safety
!
WARNING!
• Never open the absorber unit. It is under high pressure and can cause
injury if it is opened.
• Ensure clean and residue-free handling if silicon sealant or similar is
used. There is a risk of fire if silicone filaments come into contact with
hot parts or naked flames.
• Do not operate the device if it is visibly damaged.
• If the AC power cable for this device is damaged, it must be replaced
by the manufacturer, customer service or a similarly qualified person in
order to prevent safety hazards.
• Never use a naked flame to check the device for leaks.
• This device may only be repaired by qualified personnel. Inadequate
repairs may cause serious hazards.
• Only use propane or butane gas (not natural gas).
• Always operate the device at the pressure shown on the type plate.
Use a DIN-DVGW-approved pressure regulator with a fixed setting in
accordance with DIN EN 12864.
• Dismantle all doors for the disposal of the old device and leave the
shelves in the device to prevent accidental enclosure and suffocation.
!
CAUTION!
• Danger of crushing! Do not put your fingers into the hinge.
• Before starting the device, ensure that the power supply line and the
plug are dry.
RMLT9xxx-I-AUS.book Seite 5 Donnerstag, 7. Dezember 2017 12:53 12
To Next Page
Loading...
Need help?
General
