Installing the refrigerator-oven combination RMLT9xxx
8
6 Installing the refrigerator-oven
combination
6.1 Preparing the installation
When installing the refrigerator-oven combination, note the following:
• To enable the refrigerant to circulate properly, the refrigerator may not exceed an
angle of 3°.
To do this, park the vehicle on a level surface and check to see if the ice-cube tray
is flat in the refrigerator.
• The refrigerator-oven combination must be installed so that it is easily accessible
for service work, easy to de-install and install, and easily removed from the
vehicle.
• The distance between the refrigerator-oven combination and the rear wall must
be min. 15 mm – max. 25 mm.
• The refrigerator-oven combination must be installed in a recess so that it stands
firm when the vehicle is in motion. Note the following dimensions here
(HxWxD inmm):
– RMLT9330/9331/9335: 1605 x 420 x 615 (fig. 1)
420 mm 615 mm
1605 mm
312 mm1293 mm
RMLT9330, RMLT9331, RMLT9335
RMLT9xxx-I-AUS.book Seite 8 Donnerstag, 7. Dezember 2017 12:53 12
To Next Page
Loading...
Need help?
General
