Dometic 9500 - Specifications

3
B. Specications
1. Mounting bracket spacing. See FIG. 1.
a. 8' - 13' models require (3) brackets.
b. 15' - 16' models require (4) brackets.
2. The spacing shown in FIG. 1 must provide a
mounting bracket behind each shoulder assem-
bly (lateral arm attachment). See FIG. 2.
PROCEDURE
A. Install Cassette Awning
1. Determine location of awning.
a. Avoid location that interferes with entry door
swing when awning is completely extended.
Note: Awning is factory preset for a 10° fabric slope, but it
may be adjusted for a 20° slope. Allow for sufcient clear-
ance to accommodate awning pitch (slope).
For a 22" entry door, the approximate clearance should be
4 1/4" for 10° slope, and 7 7/8" for 20° slope.
b. Find a solid structure in RV wall for support of
mounting brackets (if possible). See FIG. 3.
Note: Solid structure must be as wide as mounting bracket,
and span from oor to roof of RV.
IMPACT OR CRUSH HAZARD. Make sure a
mounting bracket is located behind each
shoulder assembly (lateral arm attachment)
to provide proper support. Otherwise, the cas-
sette awning may become unstable and could
bend or collapse. Failure to obey this warning
could result in death or serious injury.
Make sure entry door will open when awning
is completely extended.
Make sure the mounting surface is at and
vertical. Any tilt in the mounting surface will
cause tilt in the lead rail. Failure to obey this
notice could result in property damage.
FIG. 2
15' - 16' Model Shown
Mounting Bracket
Shoulder Assembly
IMPACT OR CRUSH HAZARD. Make sure RV’s
structure will safely and securely support aw-
ning before installation. Otherwise, the cas-
sette awning may become unstable and could
bend or collapse. Failure to obey this warning
could result in death or serious injury.
FIG. 3
Mounting Bracket
RV Wall
(Solid Structure Shown)
8' 10' 12' 13' 15' 16'
A 6 3/8"
B N/A 59"
C 50 5/8" 60 7/8" 69 1/4" 79" 116 3/8"
D 94 3/4" 115 1/4" 132" 151 5/8" 180 1/4" 191"
E 103" 123 1/2" 140 1/4" 159 7/8" 188 1/2" 199 1/4"
FIG. 1
A
B
C
1 3/8"
1 3/8"
Back View
Right
Left
D
E
6 3/8"
4"