20 4445103123
Using the wine refrigerator Wine Refrigerators
EN
7.8 Switching to Sabbath mode
In Sabbath mode, the display, interior lighting and warning signal for the temperature monitor are deactivated. When the Sab-
bath mode is activated, it switches o automatically aer 96 hours. The refrigeration continues as usual.
► Press both the on/o button and the light button for at least 5 seconds.
9
The temperature indicator ashes 4times.
9
The Sabbath mode is activated respectively deactivated.
7.9 Setting the temperature
The temperature of each temperature zone can be set between 5 °C and 20 °C (41 °F and 68 °F).
To avoid food waste, note the following:
• Adjust the temperature to the quantity and type of the foodstu.
• Store the dierent foodstu types as shown in the gures.
NOTE:
• If the temperature zones are one above the other, the temperature for the lower zone must always be just as high
or higher than the temperature for the upper zone.
• The wine refrigerator functions at its best if the dierence in temperature between the two zones is at least 4 °C
(39 °F).
1. Display the set temperature by briey pressing the up button or the down button (g. and , on page 12).
2. If your wine refrigerator has two temperature zones, set the temperature for each zone separately by using the correspond-
ing up button and down button . Briey press the up button to increase the temperature or the down button
to decrease the temperature.
9
The display ashes while you make the setting.
9
Once you have set the temperature, the display shows the current inner temperature again.
7.9.1 Setting the temperature unit (°C or °F)
You can select whether the temperature is displayed in Celsius or Fahrenheit.
► Press the light button for at least 5seconds.
9
The display shows the temperature in the other unit.
7.9.2 Displaying the set temperature
NOTE:
When using the wine refrigerator for the rst time or if it has not been used for a long time, the inner temperature
could dier from the one you have set. The temperature display ashes as long as this is the case. Once the set
temperature has been reached, the temperature display lights up constantly.
► Press the up button or the down button briey.
9
The display shows the set temperature.
9
Aer 5seconds the display shows the current inner temperature again.
7.9.3 Switching the fan on/o (dynamic cooling mode or silent mode)
The fan can be operate in two dierent modes:
• Silent mode: The fan runs only when required. The fan switches o when the set temperature is reached.
• Dynamic cooling mode: The fan runs permanently to regulate humidity and temperature. This way an homogeneous cli-
mate for the interior of a temperature zone is reached.
Silent mode
► Press the up button for at least 5seconds.
9
Three acoustic signals are emitted.
9
The fan is switched to silent mode.
Dynamic cooling mode
► Press the down button for at least 5seconds.
9
Five acoustic signals are emitted.
9
The fan is switched to dynamic cooling mode.