CD0050, CRD1050 Installing and connecting the refrigerator
13
7.1 Installing the refrigerator
A
The appliance is designed for ambient temperatures between +18 °C and +43 °C.
In continuous operation, the air humidity may not exceed 90 %.
Set up the fridge in a dry, sheltered place. Avoid placing it near heat sources such as
radiators, gas ovens, hot water pipes etc. Do not let it stand in direct, strong sunlight.
Install the refrigerator so that the warm air produced can easily flow away (either
upwards or to the sides). Therefore make sure there is adequate ventilation (fig. 3,
page 3).
The condensation which forms during normal operation of the refrigerator can be
drained off via two outlets on the appliance. For delivery purposes, these outlets are
sealed. The two outlets are located on the rear and on the underside of the appliance
(fig. 4, page 3).
➤ Choose the condensation outlet most suitable for the place of installation and
remove its cap.
➤ Insert a sharp object (e.g. a screwdriver) approx. 25 to 30 mm into the outlet to
pierce open the inside of the appliance.
NOTICE!
•
Fasten the device as described in the operating manual to prevent
hazards.
•
Keep objects clear of openings in the housing or mounting structure
(such as ventilation slots).
•
The refrigerator is only suitable for installation in a fitted niche. Once
it is installed, only the front of the appliance may be accessible.
No. in
fig. 3, page 3
Explanation
1 Cold intake air
2 Hot waste air
3 Condenser
4 Spacing above the fridge if insufficient air can circulate above or at
the side.
CD0050-CRD1050-O-EN-FR.book Seite 13 Dienstag, 10. Oktober 2017 11:13 11
To Next Page
Loading...
Need help?
General
