EPS100 General safety instructions
7
2.2 Safety when installing the device
!
CAUTION!
• Ensure that the device is standing firmly!
The device must be set up and fastened in such a way that
it cannot tip over or fall down.
A
NOTICE!
• Do not expose the device to a heat source (such as direct
sunlight or heating). Avoid additional heating of the
device in this way.
• For installation on boats:
If electrical devices are incorrectly installed on boats,
corrosion damage might occur.
Have the inverter installed by a specialist (marine)
electrician.
Electrical cables
!
CAUTION!
• Lay the cables so that they cannot be tripped over or dam-
aged.
A
NOTICE!
• If cables have to be fed through metal walls or other walls
with sharp edges, use ducts or tubes to prevent damage.
• Do not lay cables which are loose or bent next to electri-
cally conductive material (metal).
• Do not pull on the cables.
• Do not lay the 230 V mains cable and the 12 V DC cable in
the same duct!
• Fasten the cables securely.
EPS100-B-16s.book Seite 7 Freitag, 15. Juli 2016 10:13 22
To Next Page
Loading...
