Safety instructions CRE
16
•
Make sure that the refrigerator circuit is not damaged during
transportation. The refrigerant in the refrigerator circuit is highly
flammable.
In the event of any damage to the refrigerator circuit:
– Switch off the refrigerator.
– Air the room well.
•
Set up the device in a dry location where it is protected against
splashing water.
2.2 Operating the device safely
D
DANGER!
•
Do not touch exposed cables with your bare hands.
!
CAUTION!
•
Before starting the device, ensure that the power supply line and the
plug are dry.
•
If you connect the device to a battery, make sure that no food comes
into contact with the battery acid.
A
NOTICE!
•
Do not use electrical devices inside the cooling device unless they are
recommended by the manufacturer for that purpose.
•
Do not place it near naked flames or other heat sources (heaters, direct
sunlight, gas ovens etc.)
•
Danger of overheating!
Always ensure sufficient ventilation so that the heat generated during
operation can dissipate. Make sure that the device is sufficiently far
away from walls and other objects so that the air can circulate.
•
Ensure that the ventilation vents are not covered.
•
Do not fill the inner container with ice or fluid.
•
Never immerse the appliance in water.
•
Protect the appliance and the cable against heat and moisture.
•
Make sure that foodstuffs do not touch the walls of the cooling area.
CRE50-65-80-IO-16s.book Seite 16 Donnerstag, 9. November 2017 1:03 13
To Next Page
Loading...
Need help?
General
