CRX1050, CRX1065, CRX1080 Using the refrigerator
25
8.3 Releasing the lock
A
The refrigerator has a locking mechanism (fig. d 1, page 8) which is also
used to protect it during transport. The following settings are possible:
Lock (turn wheel clockwise to the end stop): The door is locked and
secured.
To open the door, lift the handle up and open it.
Vent (turn wheel anti-clockwise to the end stop): The door is slightly ajar,
but fixed in position.
Use this position if you are not going to use the appliance for a long time.
8.4 Switching off and storing the refrigerator
If you do not intend to use the refrigerator for a long time, proceed as follows:
➤ Press the on/off button until the refrigerator switches off.
➤ Disconnect the connection cable from the battery or disconnect the plug
on the AC cable plug from the rectifier.
➤ Clean the refrigerator (see chapter “Cleaning and maintenance” on
page 26).
➤ Turn the locking wheel (fig. d 1, page 8) anti-clockwise to the end stop
(“Vent”).
➤ Close the door until it latches in place.
✓ The door stays open and therefore prevents odours from forming.
8.5 Change the fuse
If the fuse in the AC socket is faulty, it can be replaced.
➤ Lever the fuse compartment (fig. c 3, page 8) open with a screwdriver.
➤ Replace the fuse (250 V/4 A).
➤ Close the fuse compartment again.
NOTICE!
Only adjust the locking mechanism when the door is open. If you
use it with the door closed, you will damage the device.
To Next Page
Loading...
