Setting up and connecting the appliance D15, D50
14
8 Setting up and connecting the
appliance
8.1 Notes on setting up the appliance
When selecting the location, observe the following instructions:
• The ambient temperature should be in accordance with the climate class
mentioned for your country in the supplementary brochure. Otherwise, it is
possible that the inner temperature you set cannot be reached or maintained.
This could also be the case if there are extreme fluctuations in the ambient
temperature.
• The appliance should stand in the coldest part of the room, away from heat
sources (ovens, heating devices or radiators).
• The location must not be damp or wet.
• The appliance must not be exposed to direct sunlight. This can damage the
acrylic coating and lead to higher power consumption.
• The ground must be level and sufficiently stable to support the wine cellar at full
capacity.
• The appliance must be sufficiently ventilated. The ventilation slots on the front of
the appliance must not be obstructed.
• Note the information on the electrical connection, see chapter “Notes on the
electrical connections” on page 15.
• Remove all the inner and outer packaging material before setting up.
• Make sure the appliance is level by adjusting the feet.
8.2 Notes on installing the appliance
D15 and D50 can be built-in or free-standing.
Installation size
D15 D50
Width 300 mm / 11,8 " 600 mm / 23,6 "
Depth 590 mm / 23,2 " 590 mm / 23,2 "
Height 870 mm / 34,3 " 870 mm / 34,3 "
_MaCave_A5.book Seite 14 Freitag, 2. Dezember 2016 10:15 10
To Next Page
Loading...
