Dometic DM50NTE - Door Decor and Lock Installation

EN
DM50NTE Installation
17
6.6 Mounting the lock (lock version only)
➤ Drill a hole with a diameter of 35 mm into the decor.
➤ Mount the lock together with the lock decor.
6.7 Mounting the lock (no lock version only)
Disassembling the drawer (fig. 0, page 7)
➤ Open the drawer completely (A).
➤ Press the rail lock (A1).
➤ Pull the drawer out of the cabinet (B).
Only for DM50NTE D:
➤ Remove the two plugs (C1) from the screws (C2) of the door handle (C3).
➤ Unscrew the two screws (C2) of the door handle.
➤ Remove the door handle (C3).
➤ Remove the gasket.
➤ Remove the lock cover.
Drilling the holes (fig. a, page 7)
➤ Drill a hole (A1) with a diameter of 23.6 mm through the decor (only
DM50NTE D) and the door.
➤ Unscrew the twelve screws (B1) of the decor frame (B2) (only DM50NTE D).
➤ Remove the decor frame (only DM50NTE D).
Assembling the lock (fig. b, page 8)
➤ Put the new lock cover (A1) into place.
➤ Put the decor (B1) into the decor frame.
➤ Screw (B2) the decor frame (B3) onto the door.
➤ Install the door lock (C1).
➤ Install the lock catch (D1) in the cabinet.
DM50NTE-IO-16s.book Seite 17 Dienstag, 28. Februar 2017 3:33 15