MAINTENANCE
INSTALLATION
USE
-MANUAL IGNITION HOB
Manual ignition when the appliance is not tted with the electronic ignition feature or in the event of failure in the
electronic ignition.
IF THE BRUNER DOES NOT IGNITE IMMEDIATELY REPEAT IGNITION AFTER
HAVING FOLLOWED EACH STEP BELOW:
• TURN THE KNOB TO “SMALL FLAME”
• PROCEED WITH MANUAL IGNITION
• CHECK THERE IS SUFFICIENT GAS IN THE GAS BOTTLE.
IF THE APPLIANCE STILL DOES NOT IGNITE SHUT OFF THE GAS SUPPLY AT
THE MAIN GAS TAP AND CONTACT YOUR LOCAL DEALER.
MAKE SURE THERE ARE NO PANS OR OTHER ANY OBJECTS ON THE BURNERS
WHEN IGNITING.
To ignite burner, gently push-in and turn the control knob to position HIGH FLAME and maintaining the knob pushed at
the same time light the burner with a match or gas lighter. Once the burner is alight maintain the knob in this position
for a few seconds to ensure the ame remains alight.
IF THE BURNER DOES NOT IGNITE IMMEDIATELY CHECK THERE IS
SUFFICIENT GAS IN THE GAS BOTTLE.
IF THE APPLIANCE STILL DOES NOT IGNITE SHUT OFF THE GAS SUPPLY AT
THE MAIN GAS TAP AND CONTACT YOUR LOCAL DEALER.
- HOB FLAME REGULATION
To regulate flame turn the knob to the desired cooking flame.
VISUAL FLAME CONTROL
Depending on the type of gas used the ame should be:
Propane (G31): blue ame without yellow tips.
Butane (G30): ame with yellow tips when ignited which becomes more intense in colour as the burner heats.
ENGLISH
18
MAINTENANCE
INSTALLATION
USE
GAS CYLINDERS/BOTTLES
The appliance runs off standard gas bottles which can be found in the country of use. The type of gas to use is clearly
marked on the packaging and on the specications label afxed to the rear of the appliance. However always respect the
following instructions: gas bottles must always be located and positioned in the compartment provided for this purpose.
They must always be vertical and tted with a valve and pressure regulator. Do not obstruct or impede access to the
gas bottle to permit quick and easy access when replacing.
WARNING! When replacing the gas bottle always take the following precautions:
a) close all gas knobs;
b) make sure there are no ames or res in proximity of the gas bottle;
c) close the gas valve on the bottle to be replaced;
d) unscrew the pressure regulator on the empty bottle and remove the bottle from the purpose compartment. This
procedure is inverted for tting a new bottle. Check for gas leaks utilising a non-corrosive uid. Do not use a water
and soap solution.
NEVER USE A FLAME TO CHECK FOR GAS LEAKS;
e) ignite the burners to check they function correctly. If there are problems call in an authorised gas service engineer.
AFTER APPLIANCE USE ALWAYS TURN OFF THE GAS TAP ON THE BOTTLE
GAS LEAKS
We recommend the use of an electronic and homologated gas detector for checking ambient air.
If there is a smell of gas;
a) immediately open the windows and evacuate the vehicle or caravan.
b) do not turn on or off light switches or other electronic appliances, do not light matches or lighters or anything that
could cause the gas to ignite;
c) put out any ames
d) shut off the valve on the gas bottle or cylinder. Do not re-open this valve unless the gas leak has been identied and
eliminated.
e) contact a specialised gas service engineer.
NEVER OPERATE THE APPLIANCE WITH GAS AND OR AT GAS PRESSURES
DIFFERENT TO THOSE INDICATED BY DOMETIC AS THIS COULD CAUSE
IRREGULAR AND INCORRECT OPERATION. SMEV DECLINES ALL
RESPONSIBILITY FOR DAMAGE OR INJURY CAUSED BY AN INCORRECT OR
IMPROPER USE OF THE APPLIANCE.
ENGLISH
19
DometicHBH2000L-R_IOM_4445103212_EMEA12_xxxx-xx-xx.indd 18DometicHBH2000L-R_IOM_4445103212_EMEA12_xxxx-xx-xx.indd 18 27.10.2020 16:22:4927.10.2020 16:22:49